Welcome to Jiujiang fire fighting equipment Co., Ltd
ADD：No.1,Daqiao Road,Yujiahe,Lianxi District,Jiujiang City,Jiangxi province,China
Jiujiang fire fighting equipment Co., Ltd © CopyRights
Jiujiang fire fighting equipment Co., Ltd
Hydraulic motor pump BJQ-63/0.35-B
|engine model||Honda GX35 Gasoline Engine|
|Rated high pressure output pressure MPa||63|
|Rated high pressure flow L/min||0.35|
|Weight (including hydraulic oil, engine oil, gasoline) kg||12.9|
|Connector type||Double pipe single connector|
|Recommended fuel||92# unleaded petrol|
A) small size, light weight, easy handling.
B)small power, high efficiency, to meet the normal use of light hydraulic rescue tools.
C)easy to start, stable work.
D) automatic conversion of high and low pressure, so that work can be safely and effectively run.
(I) starting up
A) Before starting the motorized pump or gasoline engine, check the oil level of the hydraulic oil and the gasoline
engine and check the fuel level of the fuel tank at the same time through the oil window and the oil dipstick.
B) Use the matched high-pressure hose or rescue tool to bring the same type of hose and pressure operating connector
to connect and secure the motor pump.
C)off a small choke, the upward direction is pushed off, the downward direction is pushed open.
D) Adjust the throttle and turn clockwise to 1/3 (accelerator clockwise, decelerate or idling counterclockwise).
E) finally the hydraulic pump manual switch, turn counterclockwise OFF position (empty load). After the above are
ready, you can start the gasoline engine. After the speed is stable, fully open the choke valve.
When you need to work, turn the manual switch clockwise to the ON working position and apply a little force. At this
time, the rescue tool can operate normally.
(II) shut down
A)When the work is required to stop, turn the throttle control switch counterclockwise to the idle position first to
reduce the engine speed.
B)Close the choke valve and at the same time turn the hydraulic oil pump manual switch to the counter-clockwise
direction OFF position (empty load).
C) turn off the power, press the power switch on the engine, then the engine stops running.
D)Remove the hydraulic tool and cover the dust cap.
E) emergency stop: In case of emergency, you can directly shut off the power switch (used under normal working
conditions is strictly prohibited).
A)The hydraulic motor pump should be placed or operated in a horizontal position as much as possible.
B)Before using, adjusting, and maintaining the engine, read the operating instructions for the small gasoline engine
carefully. Check the three oil levels before starting.
Working hydraulic oil is generally selected aviation hydraulic oil. Do not add slop oil. Gasoline tank fuel level:
Add more than 92# unleaded gasoline as required, do not add too much to prevent overflow.
C) The valves in the hydraulic motorized pump have been debugged before leaving the factory, and they must not be
D)During the training or rescue work, when the supporting tools stop working, the fuel circuit breaker shall be
unloaded and unloaded in time, and the carburetor throttle shall be closed to make it idle or stop. Try to avoid
long-term motor pump full negative
Work under load to prevent the oil temperature from being too high and affect the service life.
E) according to the use of regular inspection and replacement or supplement of hydraulic oil and engine reducer oil
(gas engine oil).